Username: Cisco
Password: Cisco
AP> enable
Password: Cisco
AP1240# debug capwap console cli
AP1240# debug ip udp
AP1240# debug capwap client error
AP1240# no debug all
AP1142# write
AP1142# copy running-config startup-config
AP1240# clear lwapp private-config
AP1240# erase flash:
AP1142# write erase
AP1240# sh flash:
AP1240# erase ver
AP1142# lwapp ap controller ip address 192.xxx.xxx.005
AP1142# conf term
AP1240 (config)# interface GigabitEthernet 0
AP1240 (config-if)# ip address 192.xxx.xxx.005 255.255.255.0
AP1240 (config-if)# speed 100
AP1240 (config-if)# duplex full
AP1240 (config-if)# exit
AP1240 (config)#exit
AP1240# sh interface
AP1240# capwap ap ip address <IP address> <subnet mask>
AP1240# capwap ap ip default-gateway <IP-address>
AP1240# capwap ap controller ip address <IP-address>
AP1240# show capwap ip config
AP1240# capwap ap hostname <name> (optional)
AP1142# sh ip iterface b
AP1142# sh capwap ip config
AP1142# delete flash:private-multiple-fs
AP1142# archive download-sw /force-reload /overwrite tftp://10.0.0.2/c1140-rcvk9w8-tar.tar
AP1240# no debug all
habilitar el debug
qutar (deshabilitar) del debug
guarda la Flash
quita la IP del controlador en el AP
borra la flash
borra nvram
ver los ficheros de la flash
ver lo que ocupa la nvram
pone la IP del controlador
conectar al interface
configura la dirección IP
fuerza la velocidad a 100 Mb
forzar a full dúplex
muestra la configuración
arrancar con los valores por defecto
deshabilitar del debug
